Online tools
Engineering calculators and viewers for Modbus, RS-485, analogue scaling, pulse measurement, vibration and industrial network planning.
The tools help engineers review serial networks, register data, CRC values, analogue scaling, loop power, sensor conversion, pulse rates and vibration frequencies. Use their results as design and commissioning aids, then verify against the controlled product specification and the installed system.
Online calculations support design and commissioning, but results should be checked against the latest product documentation and project requirements.
Results are engineering estimates. Verify assumptions, ratings, wiring, standards and the latest controlled product documentation before implementation.
Use product-specific datasheets, manuals, application notes, drawings, software, firmware and certificates. Confirm document revision and model applicability before use.
Engineering tools with clear assumptions
Online calculations support design and commissioning, but results should be checked against the latest product documentation and project requirements.
Tool
PublishedSearch verified proportional-solenoid part numbers, review brand status and screen a new raw coil against Titania ISO808A direct-drive rules.
Tool
PublishedConvert RPM, hertz and CPM; calculate machine orders, bearing defect frequencies and gear-mesh frequency.
Tool
PublishedConvert pulse frequency, pulses per revolution, machine speed, accumulated counts and engineering totals.
Tool
PublishedCalculate IPv4 network ranges, masks, broadcast addresses, usable hosts and a suitable subnet for the required device count.
Tool
PublishedConvert IEC 60751 RTD resistance and NIST Type J, K or T thermocouple EMF to temperature and back.
Tool
PublishedCalculate two-wire cable drop, terminal voltage, power loss and 4–20 mA loop voltage margin.
Tool
PublishedScale current or voltage signals between engineering units and common PLC raw-count ranges.
Tool
PublishedCheck termination loading, fail-safe bias voltage, resistor dissipation and transceiver unit-load capacity.
Tool
PublishedTurn field-signal and communications requirements into a Titania configuration summary and documented-variant recommendation.
Tool
PublishedDecode register bytes into signed, unsigned, floating-point, hexadecimal, binary and ASCII values with selectable byte order.
Technology insights
Practical guidance derived from the current PyXis and Titania technical material.
Technology article
A practical guide to the three motion quantities used in industrial condition monitoring and how they complement one another.
Read more
Technology article
How RPM, 1X order information and harmonic amplitudes improve vibration interpretation on variable-speed and geared equipment.
Read more
Technology article
A structured approach to mapping vibration, alarms, machine settings and prognostic data into PLC, SCADA and CMMS systems.
Read more
Technology article
How to select the input mode, reference common and filtering for switches and industrial sensors.
Read more
Technology article
Design considerations for 1 kHz digital inputs, 32-bit counters, edge selection and reliable pulse capture.
Read more
Technology article
How protected 24 VDC sourcing outputs should be applied to solenoids, relays, lamps and other industrial loads.
Read moreHow we can support you
Tell us your company, country, application, required quantity, signal types, protocols, installation environment and target delivery date.
